About jeffhouston

jeffhouston · 01-10-2015

I have a Cisco 2811 router functioning as LAN router for an Ethernet handoff from my ISP. The connection is supposed to be 25MB yet all I can get is 8 at best and the speed varies from .18 to 7.9 up and down. Neither interface shows any errors but I ...

jeffhouston · 12-29-2014

Hi,How can I isolate VLAN 121 from all others? I have a cisco 2811 router connected to a 3560 catalyst switch which has 5 VLAN's of which I need to protect IP traffic of 4 from 1.The following VLANs configured on the switch:VLAN 0 192.168.132.0 /24VL...

jeffhouston · 12-29-2014

Hi,Will a Cisco NM-2FE2W Network Module work in a 2811 router and if so what are the commands to set it up? I know how to setup T1 controllers but is this the same or similar or what? (presuming the module will work?)Thanks!

jeffhouston · 12-12-2017

I am having a similar issue except I cannot get vWSA to recognize NIC's in Windows Hyper-v S100v. My goal is to convert S170 hardware into virtual. My hardware appliance is running M1 (management), P1 (data), and L4 traffic monitor as Simplex TAP: T1...

jeffhouston · 12-05-2017

Is there any detailed information about setting up vwsa on Windows Hyper-V? I have been able to get a shared license, download the vhdx, install and setup the VM but I am having trouble getting the interfaces up. After I did the initial setup my P1 i...

jeffhouston · 01-16-2015

The problem I had was that any Cisco or possibly any other device when plugged into the Telco Systems T-Marc switch had incredible latency. There was something about the way a PC's Ethernet port saw the connection vs. a router or switch port that the...

jeffhouston · 01-13-2015

Hi Reza, Thanks for your post.I have tried changing the Speed and Duplex on the interface to static settings but it didn't make a difference.I could use my switch instead of the router but as I mentioned in my original post; I have 3 other similar co...

jeffhouston · 01-12-2015

Hi Reza,Unfortunately I don't have a functioning switch of that caliber available to me but I think I see where you're going with that; to see if how a different piece of equipment handles the connection?All I have on the shelf is a Small Business cl...

Member Since	‎11-06-2006 12:55 PM
Date Last Visited	‎09-06-2024 08:32 PM
Posts	11

User Statistics

User Activity

2811 connection problem with T-marc switch

VLAN's, subinterface, access-lists and 3560 catalyst switch?

2811 service module compatability

Re: What Virtual interface is the TAP / P1 in S300v?

Re: Steps to Deploy Virtual Web Security Appliance (vWSA)

The problem I had was that

Hi Reza, Thanks for your post

Hi Reza,Unfortunately I don't