Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've managed to get the 2811 router T1 and associated serials up and running and I have the 2960G switch up and running. I connect a PC to the switch port of choice and recieve the proper IP/Subnet Mask/Default Gateway/and all DNS information. Howeve...
I would appreciate some input on how to impliment my network design using the equipment listed in the diagram. I'm under the gun to finish this project so a basic idea of FE 0/0, FE 0/1, and switch set-up is greatly appreciated. This is little bit be...
Well in the last 4 day i've learned alot. Started with no Cisco experience at all and managed to install and configuer a 2811 with VWIC 2 port T1/E1 card and get the T1 interface and serial subs up/up. Now i'm moving on to the switch. New bigger i as...
I'm new to Cisco Equipment, so please bear with me as I seriously belittle myself in efforts to understand what the heck to do first.I called Cisco Pre-Sales and described to them what I wanted to accomplish.1. I have a t-1 comming into a building.2....
ip route 0.0.0.0 0.0.0.0 10.60.9.61it's there, it's the one they gave me to setup the T1 Frame-Relay.I got 6 static IP addresses72.242.113.65~70they said:Public IP Block: 72.242.113.64Subnet Mask: 255.255.255.248First Useable: 72.242.113.65Last Useab...
In the diagram my 2811 router connects via T1 thru interface T1 0/0 with the sub interfaces (serial) successfully up/up. now i need to know how to configure the FE 0/0 and FE0/1 interface to connect to my Cisco Catalyst 2960G-48TC Switch so I can pla...
I'm new at this but i noticed you left out the "speed 64" at the end of your channel-group statement.try this:# configure terminal(config)# controller T1 0/0/0(config-if)# framing esf(config-if)# linecode b8zs(config-if)#channel-group 1 timeslots 1-2...
