Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there, suddenly some TenGigabitEthernet interfaces on an uplink of an access switch (C9200l-48P-4X ver. 17.3.4b) begin to flap, which means that the line protocol goes down and up again after approx. 2 seconds. The uplink leads towards an distr...
Hello, I resetted the old ASA 5505 back to the factory results, but DHCP is still not working. Clients on port 1-7 dont get an IP address, I also renewed the network interface driver. The Gateway interface is on port 0. Do you have any suggestions to...
Thanks for your answer. The document refers to overlapping source ports combining SPAN and RSPAN (L2 Barrier) --> in my case i would probably need to configure local SPAN and ERSPAN (L3 Barrier) together.
T2/1/2 is the interface of the access switch (C9200l) and t1/0/19 is the interface on the side of the link on a distribution router (C9500)They are bundled in po6, so there is no port channel mismatch.
