Our client's server is corrupted and i need to rebuild it however i was unable to install restricted version of CUCM becuase this server is preinstalled with a CUCM Unrestricted version from manufacturing before. A retricted version of the installer ...
Hi guys!I have installed CS-1300-65 everything was done already [NPA, room assessment, etc3x] however our client's isp provider is asking me about CTX audit report. Your suggestions and help is highly appreciated.Thanks
Hi, I have two FAX machines connect to one ATA 186, they can send and recieve outgoing and incoming FAX from PSTN. However they can not send and recieve FAX to each other.
I have an ATA configured to our call manager it was running for a few months when suddenly last week I can not hear any dialtone from the 2 analog phones connected to it. I tried to connect other analog phones to check if the phones were the ones def...
I have a new VG 224 but when i checked it on its show running configuration i dont see any voice-port x/x. I tried to configure a voice port configuration but the gateway rejected the command. I also tried to reboot the gateway but the result is stil...
Hi Alex,After adding some configurations both on Branch A and HQ Router, Branch A can now call HQ however when HQ will call Branch A after 5 secs the call drops. I initiate debug voice ccapi inout on both sides and i got a Disconnect Cause=63 on the ...
hi abukuru95,Both has the same partition are on the same CSS and they can call each other. When I send FAX from either of the Fax machines to the other I just heared a fax tone then after awhile the call disconnects.Mike
