Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way I can select a subset of the access point on controller, group them and apply data rate configuration to the group.I have a building with multiple floors. I want to use a single floor as a test bed for disabling some low data rates in...
Is there a way to limit the number of logins from a particular set of credentials in Cisco Prime 2.1? I want to set a maximum of 2 logins from a particular user on the wlan. I have a guest wlan using layer 3 security and an internal wlan using RADIUS...
I'm Trying to install a 50AP adder license to a 5508 controller. It fails with "Installation Process Failed : Installation of licenses failed". I see the file actually tranfered successfully on the tftp server.
Quick question guys,I am new to CSM. I have worked with Checkpoint Management for some time now and have implemented what they call Management HA. Its the the configuration of a secondary server running the software and configured to be synchronized ...
Ok guys,I dont know if this has been something thats frequently required, but anyway here goes.Lets say I have a DMVPN consisting of 2 HUBs at one location and a third HUB at another location. There are also a couple spokes scattered about. Now there...
It seems to be resolved now. I rebooted the controllers. After reboot I tried again and it failed with a different error. It complained that it required the LDPE license. Once I downloaded and installed that it was fine.Thanks ERIC
Hi Matt,I had the same problem.In WCS, click the services link and go to synchronize servicesOn the left habd side, click the controllers linkSelect the Controller(s) you want and click the 'Change MSE assignment' ButtonThere you will have the optio...
Is there a way that i can perform the destination NAT on the packet based on the source in that same packet.I want traffic coming from only specific hosts to be desination NATed on entry to the outside interface.This is because i want all other comm...
I am tryig to implement this now. I have the traffic reaching the secondary site router. How do I compose the NAT command so that the route to Null0 does not discard the packet? Should the tunnel interface be the outside nat interface?
Thanks very much Marwan,However, the IP SLA would be used just for the main site router to check the availability of the server. For instance if it is taken offline for maintenance. In this case, we would want to the spokes to send their traffic to ...
