Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to upgrade the software version of my ME from 8.6.101 to 8.5.151. Yes, actually a downgrade to a preferred version. I've applied the necessary info into ME GUI to TFTP the code. In the Software update tab, you can see that the AP is rec...
We've been receiving this log message on an ASR100x:
Aug 8 14:32:19.292: %IOSXE-3-PLATFORM: F0: cpp_cp: QFP:0.0 Thread:046 TS:00004977608472352025 %ATTN-3-SYNC_TIMEOUT: msecs since last timeout 4977561996, missing packets 114668
Shortly after thi...
Hello,I am running a 1712 12.4(25d) with NAT, VPN and FW/IDS. I have a broadband ethernet connection at 20mb. As I run some traffic through it, the processor jumps up to near 100% and throughput comes to a screeching halt. IP CEF is turned on and ...
We are running a 4507R SupII+ switch with WS-X4548-GB host modules. After a host reloads and comes back online, the switchport dies. Attempting to shut/no shut the port, the following message is logged:Aug 15 15:32:14.164 UTC: %C4K_SWITCHMANAGER-4-...
I have a GRE tunnel established between two 6500's with a VPNSM (12.2(18) code). During configuration, many packets were dropped at the tunnel interface due to the packet size exceeding the MTU and the DF bit set. This has been resolved and we are ...
I had this issue as well. It started on the ME controller when I changed it's default gateway IP on the web interface. Apparently it required a reload of the controller to clear.
Only http and tftp are available option for this controller. FTP is used to send files from the AP. All the directories that I want to view are "permission denied".
I just tried your suggestion, and it downloaded the code. Below are the syslogs: 01-04-2020 08:01:53 Syslog.Info 10.1.1.4 WAP: *httpImgDwnldTask0: Jan 04 08:01:52.846: %CAPWAP-6-IMAGE_PREDOWNLOAD_END: capwap_ac_img_dwnld.c:481 Pre-image download has...
