Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In a data centre which uses VTP trunks to connect user VLANS to the same core switches that connect server and network VLANs, if a switch is added to suppliment a user VLAN it will affect a trunk and hence spanning tree will run on all VLANS. Can I e...
In a data centre which uses VTP trunks to connect user VLANS to the same core switches that connect server and network VLANs, if a switch is added to suppliment a user VLAN it will affect a trunk and hence spanning tree will run on all VLANS. Can I e...
may have something to do with the process sequence. The ingress and egress process sequences are different. I think outbound is route then nat, inbound is nat then route.Steve
The WAE can reside on either a dedicated subnet (where redirection is not enabled) or on the subnet that has redirection enabled.If it is on the same subnet that already has redirection enabled, you will need to use GRE return to a loopback on the 45...
Sounds like the CM has overwriten the static IP address.It's probably best to boot it with DHCP, then change it to static, then register it with CMS.From here you'll probably have to deregister the WAE from the CM, set it's IP address to static, then...
