Do I need to have answer-address or dial-peers setup to handle inbound calls to the correct FXS port when in MGCP Failback or when it goes into SRST do those fxs ports know what extension they are.
Is it possible to create a SINGLE Route Pattern that will cover 800,844,855,866, 877, and 888 without using a route filter?9.18[0,4-8][0,4-8]XXXXXXX will still match more than the above area codes. Anway, just curious.
From the documentation, it appears that the Unity Bridge w/ 2.1.4 does not automatically create the Bridge Subscribers as Contacts. You have to use the tool. With 3.0, it creates them automatically. Is this correct?
From a device weight stadpoint I am well under the max. But does everyone out their think One cluster with a pub and sub is ok? 40 sites but only 900 phones. PtoP T1's to each site with the gateway's all running SRST.
For the upgrade from 2.x to 4.x I will follow the upgrade procedure to get all of the existing info. I follow that. Should I then blow away the Operating System on current Unity server, install the OS and then do a fresh install of 4.x?
Well in this link:http://www.cisco.com/univercd/cc/td/doc/product/voice/c_unity/bridge/bcg/bcg211/bnet_010.htm#1223272It says that only "Permanent" entries made in the Bridge Administrator will be added automatically as contacts. The others will nee...
I had this SAME EXACT issue. Opened a TAC case and everything with no luck. I finally got it working by installing stiback on the CRS server itself. I didn't run it from the CRS server, but by doing that the CM backup was able to authenticate...ve...
I was not sure that if when I extended the AD Schema it could have the potential to cause some interuptions that could cause the DC's or Exchange Server to be harmed.
