Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a good documnet that explains the best way to setup a site to site vpn and utilize the features of Windows domain controller. My VPN tunnels work fine but I am unable to log on to the DC. My networks are on two different subnets. I have re...
I have a client that is using AOL broadband on a road runner connection. The client needs to launch the VPN dialer and then the user logs on to a NT server in order to reach mapped drives on the server. This scenario works fine until you introduce A...
I have a old cisco 4000 series router in my home lab. I was once told that it can be set up to act as a frame-relay switch in order to simulate frame-relay between other routers I have in my lab. I am wondering if this is true and if there are any ...
I am having congestion issues with remote sites on a new frame relay network. I am using a 3725s w/ 2 FULL T1s at the host site and 2610s at 7 remote locations. Every remote site has 512K bandwidth and 384CIR. The following is the frame config from...
I created 2 pix-to-pix vpn connnections on my pix506. Since my vpn clients cannot connect. We are using Cisco client ver3.5.2Client log shows Msg. severity 3 Invalid Protocol id (0)Thanks*PIX CONFIG*PIX Ver6.2(2)access-list 110 permit ip 172.20.0.0 2...
Thanks for the reply. I am using PIX 501's running 6.3 I will do a little more homework based on the reply you left. I will certainly post more if I cannot resolve the issue.
Thanks for the reply. In my routers this command is just not available.Cisco Internetwork Operating System SoftwareIOS (tm) 3600 Software (C3620-I-M), Version 12.2(5d), RELEASE SOFTWARE (fc1)Copyright (c) 1986-2002 by cisco Systems, Inc.Compiled Sat...
