Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I got 2 boxes of Cisco TelePresence MCU 5320 with a stacking cable. The cluster of them is not being formed due to the firmware version mismatch: 4.4(3.57) is the master, 4.5(1.75) is the slave.As these devices reached EoL many years ago, I can...
Hello,I'm trying to setup a pretty simple solution for web servers load balancing using ITD on Nexus 93108TC-EX with NX-OS 10.3(6)M.There is a Deployment guide for Direct Server Response (ITD Service), and I'm following it with 3 exceptions:Ingress ...
Hi all,One of the two ISR4431 started to boot into errors after power outage. I can enter ROMMON, able to boot many different IOSes (including external TFTP download via Gi0 interface), but all of them got stuck & reboot with the messages below (more...
Hi all,I have old 7911 phone which randomly stops loading firmware via TFTP.The process begins as expected, phone loads term11.default.loads, then jar11sip.8-2-0-55.sbn, cnu11.8-2-0-55.sbn, apps11.8-2-0-55.sbn and no more.It may stop loading file par...
Thanks,I don't have any 1832i to try. I may rely on your messages, and we can try to do this together. Please contact me directly posting the results following my manual above. Let's see where are you stuck.
Hello,Sorry, but sharing contents like this breaking the rules of this community, because of intellectual property of the vendor. We have discussed this previously in this thread.
It looks like you have an empty NAND fs partition. You're absolutely right: you need to load a prebuild UBIFS image.Don't try to load tar file in u-boot, this won't work. Try to follow my instructions in the original post to build an ubi image and lo...
Hi,Could you please share your boot log in console? And the session when you are trying to convert AP to ME, including all entered commands and their output, errors, etc.
@wwigman Have you succeded with bad blocks? In my case I've marked lots of them in u-boot manually, but this did not help. Despite the correct writing and reading in u-boot, errors still appeared during the normal boot. At the end I've figured out NA...
