Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have an issue with 4500 switch, we have supervisor engine 2 plus (WS-X4013+ )and it is working fine with switch 4506, but I have a requirement so need to use this old sup in a new chasis which is 4503-E. Whenever I use this sup with new 4503...
Hi All,I have a problem in CW with Campus user tracking, in the device list it showing mix of Ip-addresses and hostnames.It is same for the case of vlans as well, some place it display Vlan ID but in other page it shows vlan names.How can I solve thi...
Hi All,I am facing a problem while configuring Virtual switching system(vss), I need to configure dual active scenario with IP-BFD but whenever I try to configure the interfaces with command "bfd interval 100 min_rx 100 multiplier 3"it gives me an er...
Hi all,I have a 3560 switch with version -(C3560-IPBASE-M), Version 12.2(25)SEB2.whenever I reboot the switch it will take 20 minitues to come into normal mode. Upto 20 minitues the "sys" LED will be blinking. I tried upgrading IOS still I'm getting ...
Hi Clarke,Yes I am getting corect information of switches in UT report taken from device center, but if I take the whole UT report of switches from Campus manager then there is problem of mix of IP and host-name.Before upgrading CM to 5.0.3 I was get...
Hi Clarke,Yes 192.168.108.50 is still showing ip address.the following devices have same issues:192.168.103.50,192.168.108.50,192.168.110.50,192.168.112.47,192.168.113.49,192.168.119.50,192.168.120.50There is something strange is happened, when I che...
