Hi guys,I need some advice on a NAT problem.I have R4 connected to R1 over a point to point serial link (Outside). IP addressing is 172.16.1.0/29 - .1 is on R1 and .2 is on R4. R4 has a loopback 3.3.3.3 (Inside). R1 is on a LAN with R2 and R3. The n...
Hi guys,When doing CCM labs, it is sometimes necessary to start with a fresh CCM config, i.e. no phones, no partitions, no CSS etc. Is there a quick way to clear the CCM config rather than to delete everything that's been configured individually?
Hi guys,I have a 2651XM router installed with an ATM-AIM module and a VWIC-1MFT-E1 card. This was decomissioned a while ago but it used to be in the production network and provided PSTN connectivity via an E1 circuit. The question is, that I expected...
Hi guys,I did a fresh install of CCM4.2(3) on an MCS 7835-H2 with 1GB RAM and dual 18.2GB hard drives. The problem is that the CCM service keeps stopping. I get the following message in event viewer:"The Cisco CallManager service terminated unexpecte...
Hi all,When I backup the Publisher to a share on the Subscriber (same LAN). It works. The tar file size is 365MB. When I specify a shared drive on a remote server, it fails. I've checked space/permissions etc. All ok.Any ideas? Log file is attached i...
Hi Sankar,I am having similar issues. On an inbound call from a H323 gatekeeper controlled trunk, the CallManager doesn't invoke an MTP, only a transcoder. This doesn't allow me to use supplementary services on the IP phone. I cannot hear the PSTN if...
Thanks guys.I'll summarise:1. The module that I have is an AIM-VOICE-30 even though it says ATM-AIM in "show diag".2. I can make 16 simultaneous calls to the PSTN because each DSP provides 4 channels.Is this totally correct?If you could provide a URL...
Thanks for that.The doc says "Three AIMs are described in this data sheet: an ATM AIM called AIM-ATM, a Voice AIM called AIM-VOICE-30". 4 .In the show diag output, it shows ATM AIM. I would have expected it to show ATM-VOICE-30??5. Can you explain fr...