Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6509 with a Sup 720. In the log I am getting the following error messages. cat6509-1-msfc-dc#sh logSyslog logging: enabled (0 messages dropped, 136 messages rate-limited, 0 flushes, 0 overruns) Console logging: disabled Monitor loggin...
If there is nothing connected to it you can tell by, if it would say auto where it shows duplex and speed. See below is a show interface of a port set to auto.
Try this. Its rommon recovery for a 2600 but it should be the same pricipal as a 2800.http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a0080094a0b.shtml
Sounds like some sort of software error. I found the following on Ciscos website.You might want to open a TAC case. %SYS-2-CHUNKSIBLINGS : Attempted to destroy chunk with siblings, chunk [hex] Explanation A software error occurred. Recommended Ac...
