Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone!I've got a Cisco 200 Micro Webserver (mweb200) with a damaged scsi harddrive.I've ordered a new one now , but i dont know how to format it when i will put it in the micro webserver. The documentation clearly says "The Micro Webserver 2...
Hello Everyone!I've tried to setup a network with one Catalyst 2950 and one Catalyst 2900XL.The problem is that the link wont go up.I've tried about 5 ports and none of them worked. I get a link when connecting a computer to these ports.But there is ...
Hi , i've recently got a 2900XL which is running very slow. The network traffic passing through is at very low speeds (2 mbps). I've tried to use a CNET switch instead of the 2900XL and the traffic is about 5 mbps. So , does anyone know how to config...
Hi everyone, i've recently got a Cisco 200 Micro Webserver without any software , and no CDROM...The problem is that the SCSI Harddrive wasn't formatted and i don't know which filesystem to use on this disk...I get a lot of errors about /local , i've...
I've checked the list of PartitionMagic and it doesnt support uvfat , only FAT,FAT32(vfat),NTFS,EXT2, and EXT3. Also , i dont know if i should create a regular partition table on the disk , or create the filesystem directly on the disk, could anyone ...
Thanks!It looks like the cables i tried didn't work. They were marked as crossover-cables but none of them were. I then found a real crossover cable and got a link and a duplex missmatch and thats now fixed. Thank you!