Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I am hoping someone can provide some advice regarding an ASA in transparent mode sitting in the middle of a .1q trunk.Scenario is two switches (one routing) has multiple VLAN's setup and then a trunk down to a L2 switch which then has all...
Hi everyone,Since firewalling is not my strongest suite I am just after some best practices for the following scenario.I have a VoIP setup with handsets connecting to 3750 switches (and the computers hanging off the VoIP sets) with all voice traffic ...
Hi everyone,I am having a few problems getting HSRP going between two 3560G switches. Below is an excerpt of the configurations from both;SWITCH-1interface GigabitEthernet0/2no switchportip address 192.168.112.13 255.255.255.252speed 1000duplex full!...
Hi everyone,Just cuirious if anyone has setup something similar before. We have a clustered setup for customers, where we setup a virtual server on the 6509 which then load balances across multiple servers.What I want to do is somehow track the serve...
Hi Roman, Unfortunately, as far as I am aware there is no workaround at this point in time. This deployment method of NLB is not supported on the Nexus 9000 platform as documented in the NX-OS release notes. You could reconfigure the NLB cluster to u...
Yes, there are non-disruptive upgrade paths available but you need to exercise caution and understand the upgrade path and any limitations. You can go from 5.2(1)N1(2) to 7.0(6)N1(1), then from 7.0(6)N1(1) to 7.2(0)N1(1) as non-disruptive but there a...
There is no "aaa accounting commands" command in NX-OS because it doesn't have the concept of privilege levels like IOS. All user activity is controlled through RBAC/group membership. The command you already have is all that is required for NX-OS to ...
Policing cannot be applied to a SVI, it must be applied to physical ports. As taken from the QoS configuration guide;Although the policy map is applied to the VLAN SVI, any policing (rate-limiting) action can only be performed on a per-port basis. Yo...
