About RickMo

RickMo · 06-20-2024

I have an RV340 and can't get the failover to work properly. I remembered, though, that both WAN devices have the same IP address. Could this create a problem? Does the RV340 ever need to reference the IPs of the WAN devices? What role does the devic...

RickMo · 05-25-2021

I've configured my RV340 for Dual Wan operation. Wan 1 is a cable ISP, Wan 2 is Starlink (from directly from the power brick). However, Wan 2 is always showing as "offline" in the System Summary, yet I can see port traffic on Wan 2. Does this situati...

RickMo · 06-21-2024

Thanks for the reply. The Starlink and Cable modem devices connected to the WAN inputs both have 192.168.100.1 as their IP addresses. If I can connect to them individually, entering that IP address takes me to their web GUI.

RickMo · 05-28-2021

Eureka! Thanks so much. I figured I was doing something incorrectly. Between the two responses I finally found the solution. Seems so easy now that I know how to do it. Thanks ever so much. Appreciate it.

RickMo · 05-28-2021

Alan. Thanks for the reply. Checked my router but I don't see an "Advance Dual Wan Setting" page. However, I did notice my WAN2 Starlink DNS config is set to 8.8.8.8 and 8.8.4.4.

RickMo · 05-26-2021

Hi and thanks for the reply and info. I had followed the instructionsand configured my router for multi-WAN. I also noticed port traffic forboth WANs. (BTW, the instructions were very helpful.) I'm just curiousas to why the Multi-Wan Status indicates...

Member Since	‎05-25-2021 12:21 PM
Date Last Visited	‎06-24-2024 10:46 PM
Posts	6

User Statistics

User Activity

Both WAN input devices have same IP address (192.168.100.1).

Multi-Wan Status = WAN1 offline

Re: Both WAN input devices have same IP address (192.168.100.1).

Re: Multi-Wan Status = WAN1 offline

Re: Multi-Wan Status = WAN1 offline

Re: Multi-Wan Status = WAN1 offline