Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community.My problem is currently the PC shows no internet and no internal communication even though the wireless client shows as connected in the dashboard.It can be said that the usage environment consists only of Meraki products.Wireless users ...
Hello, this is Cisco Community.
Only certain PDA devices cannot connect wirelessly.As for the wireless communication specifications of the PDA device, the device supports all 802.11 a/b/g/n/ac.Additionally, both WPA 1 and 2 PSK are supported in the W...
hi!
I am curious as to whether the requirements requested by the customer will be supported by the Catalyst Switch.
The requirement is that when the H.H.H PC is connected to the Catalyst Switch port A, a history of the H.H.H MAC connection to the A p...
Hello everyone.This time, you need to establish a wireless environment using the WPA3-Enterprise security protocol.The current physical connection configuration is like this:
C9500 (BB)-C9300(Middle)-C9800(WLC)C9300-PoE(Uplink to C9300 Mid SW) > C911...
Hello everyone,Currently, the FPR equipment and C9300 equipment are connected with an optical cable.It was a cable that had been in good use before.One of the FPR2130 devices failed and was restored to its original state.But the problem is that the d...
Hi Marce1000, I tried to check the MAC address of the PDA using this command, but no information was displayed.The event on the test laptop has been confirmed.If no event is displayed, can I understand that the PDA did not send any packets/data to th...
Hi bandi,
Thanks for your answer.
Since PDA device connection tests are not always performed, it seems that there will be time to extract debug data.
thank you
