Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone
I have a strange issue with WLANs. All our APs are in flexconnect configuration.
We have staff SSID and Guest SSID.
Staff SSID is using 802.1x authentication
Guest is using WPA2 authentication
We have 500mbps internet pipe
when we ...
HelloDue to some business requirement we want to disable split tunnel and want all our anyconnnect vpn users to go through our corporate internet. We have already disabled the split tunneling for remote vpn users. now problem is that users can access...
Hi AllI need some help in configuring the NAT via ASDM, my case is as follows:I have a requirement where there are multiple subnets with different CIDRs in remote LAN subnets and some of these subnets are already in use by other customers on my end. ...
Hi AllI need some help in configuring the NAT via ASDM, my case is as follows:I have a requirement where there are multiple subnets with different CIDRs in remote LAN subnets and some of these subnets are already in use by other customers on my end. ...
Hello EveryoneWe have a very serious issue going on with our cisco access points. This is our fourth AP which is fully burned out. We are using cisco WS-C2960X-48LPD-L to connect these access points. And i am getting following errors on the switch. J...
Hi RobThanks a lot for your reply on this. I have only one concern implementing the config which you suggested to enable same-security-traffic permit intra-interface. i have a concern that if we will enable this then we might be running into the asym...
Cisco Meraki Uses Auto-VPN feature unlike ASA it is limited to add manual NAT statements for individual LAN subnets for VPN traffic. Now the only option i have is to configure NAT on ASA (my side). As i mentioned customer is using a different set of ...
Hello MHMThanks for sharing this document. I already went through this document but my case is different. This document is good when both sides are performing NAT. In my case only my side which is ASA firewall needs the NAT as the other side is using...
I am thinking this NAT statement:nat (Inside,outside) 187 source static 10.1.11.0 192.168.60.0 destination static Customer-Remote-LAN Customer-Remote-LAN And I will add 192.168.60.0 in Customer-Remote-LAN object group.
