Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We have to configure a sip trunk between our pix 515e (version 7.0.4) and the service provider's sip network. Does anyone have experience on this? Is their any step by step guide for pix?RegardsIrs
Hi All, we are having a problem with cisco softphone. All routings are correct and the phone rings well. but not audio from both the ends. anyone have come across this issue? any clue where to troubleshoot? We use cisco softphone version 8.6.1.0 Rega...
Hi all,We have a requirment to place an IPS to monitor our server farm. For this we have placed 2 of our IPS 4260 in between two Multilayer switches in inline mood. Bellow is the settup.[6500 Switch]============Gi 0/2---[4260 IPS]---Gi 0/3 ==========...
Hi,We want to enable the 6PE feature in the 7609 router.But we couldn’t configure send-label command under [address-family ipv6]. We are using ios version s222-advipservicesk9_wan-mz.122-18.SXF12a.bin. Does this version supports the above feature? if...
Hi All,We would required upgrade our WiSM from version 5.1.151.0 to 7.0.98.0. So as cisco says we will have to first upgrade the software from 5.1.151.0 to 5.2 then we will be uprading to 7.0.98.0. The current Bootloader version is 3.2.202.0. Should ...
well,bellow cisco document shows the steps but its only to monitor the sip traffic. also above version 7 SIP trunk can be configure on PIX firewall. What I need is the steps to full configuratio in order to pass SIP traffic.http://www.cisco.com/en/U...
Hi All,Thanks for all your support. last night we have successfully upgraded the WiSM to verion 7.0.98.0 .Just wanna share some of the key points to be noted.Existing System information on the WiSMProduct Version : 5.1.151.0RTOS...
Hi All,Two quick questions.how can we upload the existing ios software from wism to tftp server.how can we backup the running configuration to tftp server.please adviceirshad
Thanks guys,As we planned we will go with 7.0.98.0.before preceeding with the upgrade. Incase of boot loader crashes. Is there any way to boot the WiSM in kind of ROMMON mode and upload the bootloader through a tftp server?regardsIrshad
Hi All,just two more questions prior to the upgrade.1. after upgrading the Boot loader from version 3.2.202.0 to 5.2.157.0 how can we role back if in case any issue? kindly send me a cisco link if you have.2. There are two models of accesspoints on t...
