We are currently using a login script to map drives upon logon for a user. We wanted to test using a GPO instead of a login script. We noticed that the test GPO for the mapped drive wont complete as ISE hasn't authenticated the user yet. Therefore the user doesn't see the mapped drive when thet log in. If we test the GPO without ISE it works fine. Just curious if anyone else has run into this issue and if so what helped fix the issue? Thank you, Dcosta ... View more

I'm trying to find out what port our Cisco DMP 4400 is on. When we do a show cdp neighbor we don't see it listed. Is there a place on the DMP that we have to configure to use CDP notification? Thanks, Devin ... View more

I'm trying to set up a web authentication disclaimer page for our guest wireless network. I have uploaded the files to both of our WLC4404 controllers with out a problem. I have tested the webpage from the controller after the down load and all the features work great. On the page however we have an accept button. When this button is clicked we'd like to go to a web page ex: http://www.?????.com. When clicking on this button it acts like it is going to go to the web page, the web page address is listed in the address bar but then it get's reditected back to the web authentication page. It seems like a loop and traffic is not allowed out. But again when done from the controller it works great, we can click on accept and it goes straight to the webpage. Any suggestions would be greatly appricated. Thanks, ... View more