Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Hope you are all well.I have a scenario here where i have been cracking my head to find a solution but to no avail.I have two ISP routers c800 series. One has been set up for internet gateway and the other has been set up as voice gateway-SIP...
This is my scenario:I am trying to move the webserver, ntp server, and some other internet-based servers to DMZ. I have re-imaged ASA to FTD, managed by FDM. I have some knowledge on configuring using cli, however, not much on FDM. I have configured ...
I need assistance;I have a 11.5 su3 CUCM and UCCX 12.0. I have configured UCCX all internal trigger is working. cti port registered.I also have an ISDN PRI with 100 number range. the current setup is that the first number range is translated to the C...
Thanks Marvin. I removed ip on the interface and added a subinterface and entered only one ip address with the vlan ID corresponding to the one i created in the DMZ switch and did trunking on the switch to successfully communicate between the devices...
Thanks, i understand that. However, my question is different-i am struggling to get communication from from switch to the FDM. I have configured FDM interface but not sure. This is what i did on both fdm and switch:FDM: interface 1/6 -no ip address, ...
THIS SOLVED THE PROBLEM. I CONFIGURED CODEC ON THE VGW BUT NOT ON THE DIAL-PEER. I ALLOWED CODEC ON THE dial-peer voice1000 and this solved the problem. THANK YOU VERY MUCH. ITS WORKING NOW.
