About reccon

reccon · 05-03-2022

We are experiencing a large number of output discards between two C3850 stacks (sw version 16.12.05b).They are both (collapsed)core switches in two different datacenters connected by a 10G LR single-mode fiber. It’s a layer 2 connection. Almost all o...

reccon · 11-04-2022

As far as I know Cisco dropped the wireless controller feature on the 3850 after 16.3.Try to downgrade to 16.3

reccon · 10-07-2022

[*10/06/2022 12:21:43.2191] FOUND CONFIGURED WLC (Primary) REDISCOVER TO CONNECT WITH THAT.According to that message I would assume that there is primary controller configured on the AP and it's tying to connect to this controller instead of 192.168....

reccon · 07-04-2022

"switchport trunk allowed vlan add xxxx,xxx,xxx" adds vlans to an existing "switchport trunk allowed vlan xxxx,xxxx" on that interface. If no "switchport trunk allowed vlan xxxx,xxxx" exists on that port, the "switchport trunk allowed vlan add xxxx,x...

reccon · 06-08-2022

Hi Can you post the configuration of Interface Gi0/19.Have you checked the live log of this client on the ise server at the time the authentication fails?

reccon · 06-07-2022

according to the C1000 datasheet: "Port-based ACLs for Layer 2 interfaces to allow security policies to be applied on individual switch ports." SVI interfaces are layer 3.That could be the reason.

Member Since	‎07-05-2021 05:52 AM
Date Last Visited	‎10-26-2022 12:03 AM
Posts	29
Total Helpful Votes Received	40

User Statistics

User Activity

C3850 output discards

Re: C3850 Wireless Controller Configuration

Re: 2802i Failing to Join 9800-CL

Re: tengig interface not allowing to specify vlans on trunk /catalyst

Re: dot1x client authentication every 10 minutes?

Re: Catalyst 1000 X Series Switch -- IP Access-Group Command missing?