Hi All, Turns out there was a port on the switch (older but 100mb full duplex) connecting to the AP ...

@Leo Laohoo thanks I'm just getting the exact specs. Unfortunately I don't think it's easy to remove...

Thanks for your response The APs are mounted on the ceiling, not hidden within it but exposed so the...

Hi @Leo Laohoo the glass is not certified as "low e" , but they are 8mm toughened glass

Thanks I will check this

Hi All, We are troubleshooting slow Wi-Fi speeds in a new office we are moving to. This floor has: -...

Hi Rasika, Thanks for your response Our WLC is the 5508 model with software version 8.2.166.0. The A...

Hi All, anyone that can offer any suggestions?Thanks!

Hi All, We have an odd problem with one of our HP Wireless printers. In the past few months it has r...

I had to change the public ip address of our VPN anyconnect destination and updated DNS. My Anyconne...

Hi Grant, You are right, I've spent time with TAC today and it was found that the SFR module on the ...

Just read another post on the SFR module where Marvin mentioned these modules have no concept of act...

Hi Marvin, That's my understanding as well reading up on the topic. I have that book too but unfortu...