Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I need to configure a load balance based on url filtering:All the traffic sent to https://home/can should be load balanced on a group of server (eg. x1, x2, x3); while all the traffic sent to https://home/can/<any-sub-directory> should be load...
Hi all,I've a cisco 6506 IOS SRD with a SIP-400 4GE module.I've configured one giga interface in L3 trunk with different logical IP sub-interface: on sub-interface I've configured Hierarchical-Policy (shaping + CBWFQ/LLQ).Now I need to limit the trou...
Hi all,I have a 1803 with an H-WIC 8-port switch module. I'd like to configure L2tpv3 on one of this switched port using SVI interface: is l2tpv3 supported on the SVI? Starting from wich IOS?I've read that on cisco 870 series the L2tpv3 is supported ...
Hi all,By default, PIM join messages are sent toward a source based on the RPF routing table check. If there is more than one equal-cost path toward the source, then one upstream interface is chosen to send the join message and add to the multicast d...
Hi all,I've a module ESM20G with 20 interface Giga on a 7606 (12.2(33)SRD2). I'd like to configure Hierarchical Policy on a main interface when configured with different subinterface (dot1q).I've tried with:- class-default in the parent policy with s...
Many thanks for your answer very clear.Only the last doubt: since the directory 'can' of my path could change, If I need to make two generic filter without specify the exact name:https://home/ --> to server x1,x2,x3https://home//sub-directory ---> ...
Is just this my problem: I've a router in each site where there is an AP and in the central site where there is the GW!!!! But I need L2 connectivity between AP and GW--> L2tpv3..Trouble continue...
Hi,sorry for the dealy.I need L2 connectivity between the 2 sites since I have a wireless solution where the client connected to AP needs to have L2 connectivity towards thier GW installed in another site.Anyway I've configured a tunnel L2tpv3 betwee...
ok many thanks.I'm reading your link.Any way on ISR on SVI interface the 'xconnect' command seems to be supported (12.4(15T10)): I'll try to configure it..to verify what figure out.Gianluca
