Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently running some ISR4400s as my ISP CEs and looking to eliminate these for reasons that I stopped arguing with leadership on. I believe they should be there, but honestly internet edge is simple enough I do not really need them. I did get some ...
level3isp(config)#logging host cribl.domain.org vrf Mgmt-intf transport udp port 1502^% Invalid input detected at '^' marker.level3isp(config)#logging host holevel3isp(config)#logging host ?Hostname or A.B.C.D IP address of the syslog serveripv6 Conf...
Read articles all over about ntp and vdcs, but cant seem to figure it out. N7706-01-CORE(config)# ntp commitFabric Distribution not enabled for NTPN7706-01-CORE(config)# show run | inc ntpntp server 172.24.0.202ntp server 172.24.254.9 prefer use-vrf...
Where is this 127 address coming from in my ntp peer list? 93180-01-CORE# show ntp peer-statusTotal peers : 6* - selected for sync, + - peer mode(active),- - peer mode(passive), = - polled in client moderemote local st poll reach delay vrf-----------...
UCS C-220M3 v3.0.4e Cannot use mouse or keyboard in KVM launch for esxi config changes. I also cannot use keyboard on baremetal when booting into ESXi. Using Java 8u351, which seems to be working fine, just KVM things not working. Ideas?
N7706-01-CORE(config)# no ntp server 172.24.0.202N7706-01-CORE(config)#N7706-01-CORE(config)# clock pro?^% Invalid command at '^' marker. SoftwareBIOS: version 3.1.0kickstart: version 7.3(4)D1(1)system: version 7.3(4)D1(1)
as shown in my original post: N7706-01-CORE(config)# show ntp peersINFO: System clock is not controlled by NTP in this VDCYou can use "clock protocol <protocol> vdc <vdc_id>"to change the current setting.N7706-01-CORE(config)# show ntp peer-statusINF...
