About Ozan1

Ozan1 · 09-07-2022

Hi all,I have a 3850 in which I've downgraded the code to get the wireless controller commands. I need help with configuring it to broadcast an SSID with basic WPA2 PSK configuration and extend a data vlan from the switch to clients.I ran into this w...

Ozan1 · 12-15-2021

So I have a BDI on an ASR, and it is a /24. Let's call it 192.168.1.0/24. I have an ASA connected it to it and its outside IP is 192.168.1.100 I want to advertise to my ISP 192.168.1.100/32 via BGP and not the whole /24. How do I accomplish this? ...

Ozan1 · 08-20-2021

How do you go from appliance mode back to platform mode? We are trying to convert our Firepower 2100 to running FTD. We've tried booting in rommon and applying factory-reset and boot, it goes back to loading the ASA in appliance mode. These commands...

Ozan1 · 09-07-2022

Thank you. I have an issue assigning a VLAN to the management interface. The WLC (3850 switch) does not see the AP registering. I made sure time and time zone are correct. I believe it is the VLAN. On the SW, I have assigned VLAN 200 as the managemen...

Ozan1 · 12-16-2021

I think this is it! Thank you. I knew I was missing a specific route.

Ozan1 · 08-23-2021

Thank you Ilkin. This worked. Do you recommend any books on FTD deployment? I bought Nazmul's Cisco Firepower Threat Defense book, but that is mainly showing deployment in various platforms and not the actual FTD policies, etc.The CCNP 300-710 book i...

Member Since	‎08-20-2021 11:29 AM
Date Last Visited	‎09-07-2022 07:27 AM
Posts	6
Total Helpful Votes Received	1

User Statistics

User Activity

Help with basic Wi-Fi Configuration (3850 + 3602I LWAP)

Advertise a /32 via BGP when I only have the /24 connected

Firepower 2130 - Factory Reset

Re: Help with basic Wi-Fi Configuration (3850 + 3602I LWAP)

Re: Advertise a /32 via BGP when I only have the /24 connected

Re: Firepower 2130 - Factory Reset