Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My network endpoints use the IP addressed vlans on my core cisco layer three core switch as their gateway addresses. i.e.- vlan 11 endpoint address 192.168.11.3/24 with gateway 192.168.11.1/24 (vlan ip on core) and vlan 12 endpoint address 192.168.12...
I was tasked with the setup of a site-to-site VPN on a 5512 ASA. I have my local network x.x.x.0/24 with static NAT to x.x.x.0/24 out to a remote network group including two /24 networks and a host.The tunnel is configured as bi-directional with the ...
I am attempting to power 13 POE bluetooth receivers via a single sg350 POE switch. Each receiver consumes 7.5W (5V, 1.5A). The switch will power a maximum of 11 of the receivers. Does anyone know the maximum POE output of the switch? I have been look...
I have provisioned a Mobility Express controller on an 1852i AP. Could only accomplish this by bypassing my entire network and plugging in a POE switch to both the Controller and and a newly created inside interface on Cisco Firepower FTD completely ...
How do I export my Firepower 2130 running-config to tftp server. From the FXOS CLI I entered copy /noconfirm tftp://x.x.x.x/etc. This command attempts to load from the tftp. What command copies to the tftp?
Both of you are such a great resource for me as the self-taught accidental network and firewall guy. Thank you both. Neither of the subnets for vlan 11 or 12 are being used for anything but test right now. The transit vlan 13 is also not in use for a...
I am truly sorry, MHM, but the shorthand is stumping me a bit. It is your opinion that the Switchport should remain as a vlan tagged trunk? If I configure the routes as Aref suggests it should work even as a trunk? I believe the routes are the key to...
