jreynolds4
Level 1
Level 1
Member since ‎08-31-2021
‎04-26-2024

User Statistics

  • 42 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 8 Helpful votes Received
Recent Badges
20 Replies
1 Helpful Vote
10 Replies
5 Replies
1 Accepted Solution
FirstQuestion

User Activity

My network endpoints use the IP addressed vlans on my core cisco layer three core switch as their gateway addresses. i.e.- vlan 11 endpoint address 192.168.11.3/24 with gateway 192.168.11.1/24 (vlan ip on core) and vlan 12 endpoint address 192.168.12...
I was tasked with the setup of a site-to-site VPN on a 5512 ASA. I have my local network x.x.x.0/24 with static NAT to x.x.x.0/24 out to a remote network group including two /24 networks and a host.The tunnel is configured as bi-directional with the ...
I am attempting to power 13 POE bluetooth receivers via a single sg350 POE switch. Each receiver consumes 7.5W (5V, 1.5A). The switch will power a maximum of 11 of the receivers. Does anyone know the maximum POE output of the switch? I have been look...
I have provisioned a Mobility Express controller on an 1852i AP. Could only accomplish this by bypassing my entire network and plugging in a POE switch to both the Controller and and a newly created inside interface on Cisco Firepower FTD completely ...
How do I export my Firepower 2130 running-config to tftp server. From the FXOS CLI I entered copy /noconfirm tftp://x.x.x.x/etc. This command attempts to load from the tftp. What command copies to the tftp?
Community Statistics
Member Since ‎08-31-2021 11:21 AM
Date Last Visited ‎04-26-2024 02:32 AM
Posts 42
Total Helpful Votes Received 8
Helpful Votes From