Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Above is my network setup, I have a DMZ zone and then the rest of the LAN. The DMZ is directly connected to fortigate and the rest of the LAN is connected with VLAN 1 of the switch to fortigate, the situation is as below: None of the Client PCS can ...
I am having problems using Anyconnect, I have a remote access vpn configured but I am unable to login to the vpn as there is no option to define group based authentication or to specify a username, the only option I get is to provide a key.The clien...
Above is my network design, I wanted to ask whether it is optimal or should I make any changes to it to make it more efficient Also is this layout good for STP as i am not getting much communication between the switches in this layout.
I have been stumped with this problem I have between routers and I hope some of you gurus can help as you are my last hope. The ProblemAbove is my lab setup, below is the problem I am having Router R3 is unable to communicate with the internal ips ...
I Ran a wireshark trace and saw that the packets were getting rejected as they couldnt find the LAN subnets, add a static route back to the LAN ips on fortigate and solved the problem. Thanks for the help guys.
Thank you for the reply, I will try to answer your questions in bold below" What makes you think it’s NOT the firewall - if your switchs can access the internet but you vlan clients cannot but can ping each other then it does seem to suggest to be t...
How do you propose I do that, as the default route that is connected to fortigate is through vlan 1 ips i.e. .90.0. and to check other svis I might have to define a new route maybe? Other switches can also access the Fortigate but they are also on vl...
It's is an old l3 image of a Cisco switch and yes the IP routing is enabled but not showing up in the config, it also doesn't show the switchport access vlan command but it works.As I said in the original post all the vlans are able to connect to eac...
