Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Does anyone happen to know if an SNMP MIB/OID exists for the Flexconnect configuration on a WLC? Specifically I'm looking to return the name of the Flexconnect Group that a particular AP is a member of. I've accomplished this for the AP group, b...
Hi,Would appreciate some advice, I am using a 5508 controller, I have an SSID that has WMM enabled and platinum QoS profile applied, with default settings. I have 802.11p set to none as we are not doing layer 2 QoS on the switches.I found that when ...
Hi,I'm trying to create an EEM script to monitor the status of some EIGRP peers on a specific interface. The failure detection works, the problems I have are:- The applet trigger is syslog, unfortunately there are two peers on the interface, so I ge...
Hi All,I am currently viewing the configuration of my two ISP connections.I am trying to find the best practise for filtering BOGONS.We are currently filtering them using an in-bound access-list applied to the ISP facing interfaces.Would I be correct...
Hi,Please could someone advise a good router/s for terminating approximately 80 or more x21 serial circuits, with redundancy.... Hope someone can help.Thanks,Peter
You might monitor syslog messages related to mobility peer state, the WLC sends periodic keepalive messages across the mobility tunnel to monitor state:
MM-4-INET_MEMBER_DOWN
MM-6-INET_MEMBER_UP
Pete.
Export the current configuration from the 4400 by issuing 'show run-config commands', look for the Guest user accounts, and MAC filters. Then create a mac filter and Guest user on the new 2504 WLC, export the configuration and check the syntax is th...
In order to use 5Ghz with 3502 in Brazil you need to use AIR-CAP3502I-T-K9, not AIR-CAP3502I-A-K9.If you check this table linked below you can find Brazil, and the column for 3502 AP, the correct regulatory domain is T:http://www.cisco.com/c/en/us/pr...
"Just looking for a command on the remote WLC to disconnect the APs so I can reboot the WLC with the FW on the backup then have the APs reconnect."The WLC command is 'reset system forced' this does exactly what you describe. The APs will disconnect,...
