Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have 2 routers in a branch which will connect to 2 other router in a DC via eBGP. R1 in branch connecting to R1 in DC and R2 in branch connecting to R2 in DC. What options do I have here? Should I configure router 1 in branch as the outgoing and...
Hi,I wanted to know if there is any Cisco documentation on a n+1 HA design where I have one vWLC in one DC and the second one in a diff DC geographically different. The vWLC in use will be a 9800-CL. In this scenario the mgmt ip will also be differen...
Hi Team,
On my Nexus 9k, Im getting an error on syslog which is:
%$ VDC-1 %$ %IPFIB-SLOT1-2-UFIB_ROUTE_CREATE :Unicast route create failed for INS unit 0, VRF 5, x.x.x.x/24 flags:0x0, intf:0x90048, Error: FIB TCAM FULL For IP Routes (1129381966).
V...
Hi,Can HSRP be done with a Juniper firewall ? I'll have 2 Cisco routers doing HSRP and these 2 routers will be connected to a Juniper FW (SRX-220H).Is it possible to do it or we will need a cisco switch between the Juniper FW and the 2 routers ? Plea...
Our Client has configured 2 units of SX20 as standalone and working well as point-to-point, They have CMR webex and want to know how can they call external (other) devices (mobile, customers, employee outside using laptops).
Thank you
So on the router side I'll have 2 interfaces on each router going to the switches which will be stacked. what configuration should I put on the 2 interfaces of each router in this case ? Duplicate the configuration on each interface ? Ether channel t...
Yeah but in this scenario we will have only 1 juniper FW, not cluster. Is it possible then ? Whats the the best practice ? To use a switch between them ? Or to use without the switch and make the FW do the switching for the 2 Cisco routers.
What do you mean by groups ? Aren't they by default in a single group ? Hope this won't affect the communication. Also how would we configure the juniper firewall for this ?
Yes standalone would be the correct term, not register. I went through the links before as well but i want to jott down the pros and cons for using standalone as compared to registering the SX20 with a CUCM.
