Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I got an stack with two C9200. One C9200-24P-E, and one C9200-48T-E.This stack runs in install-mode, with software version 17.03.03. The two flash: are as following : Switch#dir flash-1:Directory of flash-1:/72892 -rw- 2097152 Sep 30 2021 08:07:04 +0...
I have an AP that only flashes green, and will not boot correct. The boot stops at "Board ID (0-18):" What should I choose? 5jjjjR▒▒▒▒▒RD DQ P000000000011111111112222222222333333333344444444445555555555666666666670123456789012345678901234567890123456...
Sorry I have not answered before, have been gone a few days.This upgrade was only on two of my spare switches. These two have not been in production, and came with 17.3.3 from Cisco. The reason I am running this test is that I have two similar stacks...
These is after an successfuly reboot on new software : Switch#sh swSwitch/Stack Mac Address : 5ca6.2d2a.0800 - Local Mac AddressMac persistency wait time: IndefiniteH/W CurrentSwitch# Role Mac Address Priority Version State--------------------------...
Starting the stack in BUNDLE-mode went OK in to the 17.3.4.Then i run "install remove inactive"Change into INSTALL-mode then also went OK, and the stack successfully reboots with the new OS. Thanks for all the help Leo.
