Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am interested in using the QSFP Passive Copper Splitter Cables that breaks a 40Gig port into 4 x10Gig copper SFP+ and below is the exact part number. Can I connect the 4x10Gig cable ends to different Cisco Switches or do all four 10Gig ports need t...
The documentation states the Flex 7500 WLAN controllers support the 10Gig transcever "SFP-10G-SR" but mentions no others. Is it possible to install a 1Gig transceiver such as GLC-T or GLC-SX-MM or other types of 10Gig transceivers.
We are planning a WLAN upgrade and the security policy is to forward wireless Guest user traffic to the DMZ controllers. We are now considering the Virtual WLAN Controller and all AP's will register with the virtual controllers and we will use Flexco...
Unable to manage Guest accounts created by different WCS Lobby Ambassador user Accounts.I have setup three Lobby Ambassador accounts in WCS. Three staff members have been given seperate usernames and passwords to WCS with Lobby Ambassador profiles to...
Scott Fella, Thanks for your reply and good news that Guests can be anchored back to the DMZS controller. We plan to terminate the office extend sessions on the DMZ controller. The remote OEAP users traffic will then have to traverse through the fir...
Hi Guys,Did you ever get a resolution to this as we have a similar problem with two Nexus 5596 and we are running vPC and having problems with OSPF peering with external routers. We have created a routing VLAN 254 and trunked this on a second etherc...
Hi Keith,Did you ever get this working as I am about to start a project with Cisco WLAN controllers in a Novell enviorment and looking to use Free Radius. Any advice will be appreciated.Thanks,Stuart
Was this ever confirmed as I have a bundle with single sup-7E Lan Base and installing a resilient Sup-7E and hoping this applies IP Base to both sup-7E in the chassis, Can anyone confirm??
Hi,did you manage to monitor the 4500 module status. I am trying the same and the only method appears to receive a trap b ut we prefer to poll the SNMP OID as this is more reliable. Any help appreciated.Stuart
