Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
The WAAS setup in our company is not too big, only 15 devices using NM-WAE-502 on the routers. As we are approaching a network refresh we have decided to use ISR4331 and their WAAS capabilities. When you go thru the ezy install on the router t...
I am searching for Cisco supporting documents on what the process is to upgrade the IOS on a 3650 switch stack but cant find anything good so far. RegardsErmalG
Hello all, I have been researching this issue for a while now to no avail. I have a 2821 with a NME-16ES-1G-P module. Up to last week it was working just fine and than after a router reload it stopped working or so it looks like. I am able to get pro...
I have gone thru that manual over 10 times in the past week. I still cant get to rommon mode once i enter password recovery command while consoled in directly to the router.On the manual page 67, there is a part that I don't understand completely or ...
I have reloaded the module and the router several times these past few days but I still cant get to the switch. Unfortunately this is for my home router. Bought off ebay back in december so no coverage on it. Below is how I am trying to get to rommo...
Gig1/0 is in a UP UP state. I have tried to do shut no shut with no change. I do not see anything coming off gig1/0 on CDP neighbors.I do see the module when doing a "show diag 1"I also do think that the IOS somehow got corrupted during boot up. When...
Cehill, thank you for the link. Unfortunately I have no access at all to the service-module command line. SSH-telnet does not work and also when I try to get to it from the router it does not let me get in it.
