Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, i have isakmp working tunnels and when i convert them to ikev2. They are not coming up. As soon as i config new ikev2 tunnel profile to tunnel interface ospf neighborship went down and having below errors. There is no issue with isakmp tunnels...
Hello,Someone know how to Set Route preference from two same redistributed routes from BGP through different vrfs.I have two ISPs and learning default route from them. I want ISP1's default route choose as a priority. I am having two vrfs for them 1)...
I have UCS C220 M5SX server. For CIMC version 4.1(3c), I am not seeing any option for RADIUS authentication. Only TACAS+ and LDAP option available on GUI. Any one know how to configure RADIUS on CIMC version 4.1(3c) or help me to find out the way to ...
I have installed new NIC on my PC and configured attached ip and gateway. Also configured router with below configuration. I am able to ping from PC to router but not able to ping from router to PC. any thing i am missing?Router#sh run int fastEthern...
Hello, I am having similar issue. we are also doing migration from ikev1 to ikev2 but Configuring IKEv2 tunnels creates connectivity issues. did you complete migration? if possible can you share what steps you did for migration?
Hi @MHM Cisco World , Found the issueI was using tunnel protection ipsec profile IPSEC-Profile-1 shared command. As soon as i removed shared word on both side its working now. Thank you so much for your help.thanks,Mark
I just added match address local on both router under crypto ikev2 profile IKEv2-Profile-1. ip mtu is 1440 both sides. still same result. not sure whats wrong with ikev2 config.
