Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have experienced multiple times whenever switch got faulty and replaced, multiple cisco WiFi devices didnt come up, as switch ports didn't up, after replacing the connectors from either switch end or device end, ports come up, so my question is hav...
I have a question, whenever I connect any out of box access point, I configure that statically after joining the WLC8510, AP does not show primed IP address instead shows 0.0.0.0 after downloading Primary SW it reboots and then I would be able to see...
1. I have Ten(10) 2602i and 2702i APs on one site, all APs are intermittent, both models are mixed mode(Flex and local), I have enable link latency on all APs and Max is between 250 and 200, I have got debug logs of APs from controller and one log is...
Dear All I have 2 questions:1. If I select a static/custom DFS channel of an AP, in that case, will the DFS protocol/mechanism work? and radio will stop using the channel for 30 minutes. 2. My second question is related to AP logs while discovery and...
I have hundreds of AIR-CAP2702I-E-K9 installed on different Wi-Fi sites, that are connected to 2 WLC8510 installed on different locations, I have total 3 WLC's 2 WLC's are on 8.5.151.0 software version and 1 WLC is on 8.0.120.21, before the problem m...
First possibility, the link, end-to-end, never met spec, due to one or both RJ45 connectors not meeting spec, and the replacement switch isn't as tolerant of the link being out of spec as the earlier switch was...Well, the forgoing assumes the replac...
Instead changing the patch cords I by-pass the patch panels and also in 1st attempt We make the connectors from switch end, when devices don't come up, after making the connectors from devices end ports come up.
Joseph my question is why devices were fine with old switch, and why some didn't come up with new switch, as from device end nobody touched the cables/connectors only cables were reconnected to new switch in IDF, when connectors were made from device...
Mr Marce Thanks for reply and understand what you are saying, but that is different story I cant write here but my question was about 0.0.0.0 IP, Please if you can.Thank You
