About markverwey

markverwey · 10-27-2025

I am currently running 1 sip trunk and are using voice class e164-pattern-map XXX to route calls based on the inbound DID; all works great. I now have to add a second sip provider with a bunch of different DID's and point those calls to and from thi...

markverwey · 06-23-2025

I am working on a new solution for a customer with over 300 sip trunks from several different carriers all coming into our network then out to locations around the country through our internal network. I am trying to consolidate all of the sip trunk...

markverwey · 06-09-2025

Currently have a SIP trunk with 6000 DID numbers assigned that points all inbound calls to CUCM. New twist is that we will be adding over 2000 additional DID's that will need to point to a different voice system that is not CUCM. Would like some di...

markverwey · 02-12-2024

I have a development application that I use to test scripts before I put them into production. I was having problems getting the new script to run. I started a reactive debug so that I could step it through to see where it was failing. It never tr...

markverwey · 10-07-2021

We are using CUCM 10.5.2 and have SIP trunks. I have been fighting a problem where I have phones that are sending out a toll free number as their ani by putting the TFN in the "External Phone Number Mask" on the line page for the phones that need th...

markverwey · 11-12-2025

Ok using tenants and different interface for each sip trunk appears to work just fine. I do have something strange going on though. If I stand up a call on the new sip trunk then on the cube router, I type the following "show cube call all"If goes ...

markverwey · 10-27-2025

Thanks for the reply, With regards to 1 sip trunk requiring authentication with the SIP_UA info and the other not requiring any authentication, how do I make sure that the sip trunk with no registration requirements doesn't try and use the other pro...

markverwey · 06-12-2025

That document is great but still doesn't answer my questions. Its 1 sip trunk with 4 different sites that calls need to route to. 1 of the PBX's is a CUCM, 1 is a Fortinet PBX, and there are 2 Avaya PBX's for the other 2 sites. I am wanting to use...

Member Since	‎10-07-2021 09:51 AM
Date Last Visited	‎11-06-2025 06:36 AM
Posts	8

User Statistics

User Activity

2 SIP Trunks on 1 cube IOS version 17.12.05a

SBC using a cucm and a 8200 for a cube

Cube call routing with Trunk groups

UCCX 12.5.1 Script fails to trigger

Unable to dial toll free numbers

Re: 2 SIP Trunks on 1 cube IOS version 17.12.05a

Re: 2 SIP Trunks on 1 cube IOS version 17.12.05a

Re: Cube call routing with Trunk groups