Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to add ports to vlan 1000 Vlan 1000Name vlan interface Vlan1000 no shutdown no ip redirects ip address 10.20.55.1/26 no ipv6 redirects ip router eigrp 100 ip passive-interface eigrp 100 interface Ethernet1/1-48switchport mode access...
I am trying to apply NetFlow monitor on an interface on Cisco 9000 series. Flow Exporter, Flow Record, and Flow Monitor were all successfully configured. Switch(config-if)# ip flow monitor NetFlow_XXXX input I do not see any further commands that ge...
Hello All, I am looking for a command that shows all interfaces with NetFlow enabled. I have a mix of Nexus / IOS and cannot seem to find a good syntax that produces the appropriate output. Any insight is appreciated. Thank you,J
Hello All, Has anyone setup an HP Printer on a Cisco ASA to print internally? If so can you provide some insight. I am trying to print all on the inside interfaces and it seems like the printer wakes up when I print but it just won’t print the page? ...
Hello All, I have a Cisco ASA 5506-X I used the default config using version ASA Version 9.14(2)15 and this VPN with split tunnel tutorial to setup AnyConnect client using the Any Connect Wizard: https://www.petenetlive.com/KB/Article/0000069 The pro...
Thank you. I agree with your commands. I did find both of those and tried them. They are not available on the 7K / 5K / 9K / 3850 in our environment that have NetFlow enabled. They do show up in 3560 series. I was hoping for a command similar to : ...
