Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our customer would like to use DNAC as simple netflow collector, similarly as it would work with Prime Collector license.
My understanding:
DNAC cannot work as simple netflow collector, only as Application Telemetry collectorApplication telemetry req...
Our aim is to send email notifications when an interface of the DNAC managed switches goes into errdisabled state.
I understand that it is possible to subscribe to Events, however I cannot find any event under Platform -> Developer Kit -> Events whic...
Hi,
I have an 1800s running legacy software version. When I try to claim it with a 2.x DNA Center I receive an error, stating the CiscoSensorProvisioning SSID is not supported with the current sw version of the sensor. This is expected, as the DNAC d...
Given CSCwb01226, is there any way to keep using SSM On-Prem with SLUP capable devices added to DNA Center inventory?
Am I right to think, that the "license smart transport off" command, pushed by DNAC to the managed devices ( because of this bug ) m...
As automatic network assurance provisioning is not available on DNA Center for Cat3650, I am wondering whether it is possible to configure it manually to stream assurance/telemetry data to DNAC. I suppose some sort of netflow configuration should mak...
The following document suggests that DAI is enabled by default with SD-Access. Not explicit though.
https://www.cisco.com/c/en/us/support/docs/cloud-systems-management/dna-center/215885-troubleshoot-arp-resolution-in-sd-access.html
I have tested th...
Hi Flavio,
thank you for your response!
In my understanding Enable Application Telemetry works only with DNA-Advantage, as that is not a simple FNF but uses AVC(and AVC needs DNA-Advantage).
I just tested this on a 9300 with DNA Essential with the fo...
That is very useful, means that normal SSIDs should show up there. So now I only need to figure out why our normal SSID is not listed.
We are not managing any WLC with this DNAC yet, so I tried to create a "dummy" SSID, and attached it to a "dummy-pr...
Hi Pieterh,
thank you for your response! Is there any other kind of sensor profile than the Backhaul profile? If yes, in which menu can I create that?
( I have already tried to create a backhaul profile with a normal SSID, but DNAC GUI doesn't allo...
Turned out that everything was fine, but DNAC is only collecting Client Health(Device Tracking) data on non-trunk interface. In this case all devices in the device-tracking database was learnt on a trunk port, that's why nothing was shown in DNAC. Af...
