Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,We have a dhcp server running in our network for vlan310, we are getting ip leases when we connect a pc to a port on our first switch (C4507). There is a trunk port configured to a second switch (3750). Now when we connect a pc to a port (gig...
Hi community, we have a Cisco voice gateway connected to a sip provider on one side and an old Siemens pbx connected on the other side through 2 T1's.We are experiencing intermittent 1 way choppy voice audio issues when we call a phone connected to t...
I hope all is well ! I have a question I am trying to apply the command sip-profiles inbound to the voice service voip like I was doing before, but this particular router does not accept it.I think the command is not supported in the firmware (flash0...
hello guys we are getting an ISDN error on incoming calls on our T1 trunks connected to an old PBX, any ideas what might be the reason for these errors ? thanks in advace. *Nov 2 00:16:25.028: ISDN Se0/1/0:23 Q931: RX <- SETUP pd = 8 callref = 0x01D...
Hey guys, I have an issue with sip calls coming in from our provider, we are getting error 500 Q.850 cause 44any ideas? thanks *Nov 1 20:14:54.065: //415/822D05688518/SIP/Msg/ccsipDisplayMsg:Sent:SIP/2.0 500 Internal Server ErrorVia: SIP/2.0/UDP 123...
hello guys,we figured it out, it was a spanning-tree event that occurred and the affected vlan path was pointing to a backup dhcp server which was not active.thanks for the input
JFYI , I just tried adding playout-delay mode adaptive and it made it worse, so removed it again. I have no idea what the issue is. When I do a "show call active voice"I get the output below, it does not look like there is a problem, but the voice g...
