Good Afternoon, Situation, want to be able to take office phones from home and office and be able to use them with untagged traffic at home. Office is using VLAN 10 for Data network. We want the phones to work at home with untagged traffic, then brin...
Good Afternoon, I am trying to get some assitance on determining theoretically the correct way STP will block the ports on a 4th switch in a simple network topology. I know the tie breaker rules just dont fully understand them for the bottom switch. ...
Good afternoon ,
We have a CME set up at one location that works perectly fine.
I am wondering what ports are required to get a cisco sip 9971 to work at another location home router that is doing nat. If phone is pluged directly In to a active li...
Good Morning,
I was wondering if anyone could give a helping hand. I have SIP trunk with flow route and currently have everything working fine. I have turned on IP based authentication which only allows my static ip from communicating. After i set th...
Good Afternoon,
I am having issues with SIP phones resetting every few minutes. I can't remember exactly what caused it last time but it had something to do with the sip phones being on a different network if phones are on same network as the CME IP...
All switches in the topology have the same priority which would be the default. The diagram is labled correctly. All path costs are identical. We are being taught that FA0/1 would be root port just because the port id is less on the local switch tha...
Fixed it with the bind command.
voice service voipallow-connections sip to sipfax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback nonesipbind control source-interface GigabitEthernet0/0bind media source-interface GigabitEthernet0/0mi...
This is what flow route told me... step 1 has already been done.
No you would want to apply the configurations I mentioned into your dial plan. Essentially all that needs to happen is that on outbound calls you are prepending the tech-prefix followe...
