Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco sns-3415 that when users authenticate against a switch , in the ACS Dashboard Live Authentications I only see the username/access service and authentication type. I don't see the ip address of the switch being accessed which I also wa...
I am using acs 4.2 on a windows 2003 server sp2 in my current network. The network is being replaced and I am being given a windows 2008 software/server and to build the app. I am a little confused as too the available software. The only 5.4 acs s...
I have a 4402 being used as a dmz anchor and we use WCS to allow our Helpdesk to create lobby ambassador accounts. Recently they have been getting error messages when attempting to create accounts. I am seeing the database maxxed out at 2048. The doc...
I have a 4404 controller that the data path is up but control path is down when trying to setup a mobility anchor to a dmz controller. Any ideas?? 4.2.176 code on controller
I have a controller on code 4.2.61.0 that was upgraded to this..I have some of the legacy Nortel waps which I believe are now 1000 series cisco that constantly recycle..when waps are operational I see their code level is at 4.0.217.0 not at 4.2.61.0....
Neno...thanks for the information...I had opened a tac case and they came back with similar analysis/results.."
Found a bug, Provided the Bug ID (CSCth31525) and informed that bug is still not resolved.
Bug will possibly be resolved in next patch re...
Thanks for the info I was familiar with that command..I was hoping to have a way to determine what the entries were and how I might remove/cleanup the database..when I run the command it tells me nothing otherthan database size and that it is maxed...
this is in addition to udp ports 16666/16667?? Thanks..we have 8 operational controllers that are working fine..these 2 new ones are not coming up on the control path...
