About eric10276

eric10276 · 01-04-2013

I recently tried to manually format the flash on a model WS-2960S-48TS-L switch running IOS version 15.0(2)SE. While executing the operation I got the following error - mifs[8]: Failed to create superblock %Error formatting flash (I/O error).As a r...

eric10276 · 04-26-2010

We are considering upgrade of our 1800 series integrated services router to a 1900 series. We have port FE1 on our 1812 configured as a WAN interface using PPPoE to a typical cable modem. Can one of the standard Ethernet ports on the 1941 be config...

eric10276 · 01-22-2013

Update - I reloaded the 2960S switch and the flash memory did remount as Cisco predicted. All files in flash were gone but I successfully loaded the latest IOS release 15.0(2)SE1. After recovering the switch I am now able to format the flash memory...

eric10276 · 01-04-2013

Thanks for the input. I have used the USB port for configuration but never thought to use it for a recovery. Also I will try the "chkdsk" as I am not convinced Cisco's guidance is accurate in this case.

eric10276 · 04-26-2010

Thanks! I will give it a try.

eric10276 · 04-26-2010

So are you saying that the two gigabit Ethernet ports that come standard on the 1941 can be configured in a similar manner to the first two ports (FE0 and FE1) on the 1812? Thanks.

eric10276 · 04-26-2010

Carolyn,As recommended I would connect your computer Ethernet port directly to the modem, cycle power on the modem then go to "network connections" on your PC. Look at your LAN interface and check the TCP/IP properties. Make sure that both the IP a...

Member Since	‎04-26-2010 09:46 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	7

User Statistics

User Activity

Catalyst 2960S Format Flash Failure

1900 Series Router PPPoE Support

Catalyst 2960S Format Flash Failure

Catalyst 2960S Format Flash Failure

Re: 1900 Series Router PPPoE Support

Re: 1900 Series Router PPPoE Support

Re: Need help in connecting my DSL to Linksys