Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am doing SNMP trap testing on a Nexus 9000, but coldstart trap is not sent when rebooting or powering off/on with the reload command.The following settings are enabled by default on Nexus, but please let me know when the coldStart trap is sent.
snm...
Catalyst switches have a command to fix the ifIndex used in SNMP monitoring.
Switch(config)# snmp-server ifindex persistSwitch(config-if)# snmp-server ifindex persist
However, there does not seem to be a command for the Nexus switch.Am I correct in a...
After initializing the ASA settings, an error was output when the following settings were submitted. Could you please tell us the cause and how to configure it?
(config)# crypto ikev2 remote-access trustpoint XXXXXERROR: Trustpoint not enrolled. Pl...
Hello @anpetit
We waited for a while after starting the equipment, but could not see any traps.We are not in any particular hurry, so we will close it for now. We will contact TAC when we need to investigate.Thank you for your cooperation.
Hello @anpetit
Thank you for your assistance.
We are supposed to send a coldStart trap after the equipment has completed booting, not for monitoring purposes, but we could not receive the Trap on the SNMP server.
I would like to check the status aft...
Hello @anpetit
I checked with the following commands, but to no avail.
# show logging logfile last-index logfile last-index : 771
# show logging logfile start-seqn 100 end-seqn 200Last Log cleared/wrapped time is : Thu Feb 15 11:07:30 2024
Does this...
