Hi,I have 2 remote sites running BGP with service providers, with AS prepend tweaking on the each site's remote routes. Object tracking is used to tracked the server farm gateway IP addresses so that it can withdraws it primary route advertisement sh...
Hi,Any one configured etherchannel at a single switch across 2 pairs of AP with 5Ghz as backhaul? Does it work?Topologyswitch ----- AP1 --------- backhaul 5Ghz ---- AP3 ---- switch 2(etherchannel) ------AP2 --------- backhaul 5Ghz ---- AP4...
Hi,Anyone can point me to some post or documentation that points out what are the key differences are between WLC with and without the WCS? What are the things that the WLC can accomplish with and without the WCS?Regards,
Hi,I have a ASR 1004 with the following int:1 x Cisco 8-Port Gigabit Ethernet Shared Port Adapter2 x Cisco 1-Port 10GE LAN-PHY Shared Port Adapter1. Can I do a backup int in 1 of the 8 Port gigabit ethernet port to backup another port in the same m...
Hi,My current setup is as such:router A --- link 1 --- router B --- link 2 ---They are connected via MLPPP, on top of that, RIP is being used as the dynamic routing protocol.There is a requirement to let a group of user from router A to re...
Hi Scott,I only have a vlan that will be transversing pass the links. So based on therotical calculation, I should be getting 600Mb throughput for the backhaul?
Hi vmiller,Thanks for the assistance.The reason is that there is a specific group of user that they want to force using link A only, to make sure they do not congest up the bandwidth on the other links. The second requirement is that when that is no ...
