Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,Is there a solution on the ASA that allows a similar VPN setup as a DMVPN on a router? I'm looking to do a full mesh VPN setup and a DMVPN would be the easiest way.Any suggestions would be greatly appreciated.Thanks in advance
Hello Everyone,I am currently having an issue accessing a network through my firewall. I have access-list that allow this particular network in and access-list that allow me to this network(inside out). I have checked my acl's, static routes, rever...
Hello,I have a 64 bit vpn client running on windows xp that is not sending any traffic encrypted(bypassed only). I also have a 32 bit version running on xp that works great sending and receiving packets. Both versions receive an IP from my IP pool ...
Hello All,I have a problem with my 6500 series switch booting up. This is my first initial boot up so I am using the console cable to put ip information on the device. The switch goes through the basic boot sequence but when it finishes I am unable...
Hello,I was tasked to filter traffic on my network which consists of the following:2 x Distros and a bunch of access switches.I'm running HSRP on my vlans which works great but I have to filter outbound traffic from accessing certain things. For exa...
Leolaohoo has a point. Shouldn't you use LACPSo instead of the channel-group being set to on set it to active. Try the following:channel-group {#} mode activeThanks in advance
Can you try using Windows Explorer instead of Filezilla? ex. ftp://{IP Address of outside interface}Also check out the followinghttp://forum.filezilla-project.org/viewtopic.php?f=1&t=16565
