Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWe recently purchased 4 Cisco Catalyst 9300x 48x UPOE+ switches to use in a switch stack configuration. I have made sure that the Stack Wise cables are all connected properly but when the switches boot up only 3 switches are found and are in the...
Hello,I am having a weird issue which is either difficult or so easy I am missing it and wondering if I can get some help with this. I am working with an organization which has both staff users and public users. They use ROAS and L3 switches currentl...
Hello,I am trying to launch the Cisco Catalyst Center Cisco DNA Center Release 2.3.3.5 with ISE and it does not seem to be working. I have not received an email to launch through VPN either. Am I doing something wrong? I tried yesterday also with the...
We have a switch dedicated to our Wireless Access Points. We are getting repeated flapping of port notifications in our SEM. Any idea why this would be happening and how to resolve the issue? Here is the output from one of the events but there are ma...
Hello,We have two buildings in our campus which are quite close roughly 50 yards or so and we have an old Cisco 3560 connection back to an old switch in our building. They are using large SFPs and SC connectors. This set up is currently working but w...
I'm sorry if this is a newbie question but I am setting up a new Stackwise switch stack out of the box. It has 4 9300X 48 port switches in the stack using Stackwise cables and stack power cables as well. I have added the software auto-upgrade enable ...
Thanks again Jens and everyone for their input as well. I ended following some document which advised to do it in ROMMON but if you can do in config mode its much easier. Thank you again! With the software auto-upgrade enable I was thinking it would ...
I wanted thank everyone for your help with this. This is our first switch stack and it seemed weird to just have an issue right out of the box. Anyway, Jens I followed your post closely and it ended up being the Stack Ring Speed : 240G. You have to b...
So far on the troubled switch I found that the ring speed is wrong. The switches which are included in the stack have the following:Switch#show switch stack-ring speedStack Ring Speed : 500GStack Ring Configuration: HalfStack Ring Protocol : StackWis...
