Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OFFICIALPresumably the switch interface bounces when the AP reboots, but in my case the access point were rebooting because the WLC was too new for them to use the new version pushed by the WLC. The error on the access point consoles goes something l...
You really need to have more info in your request, a console log of an AP when it loops would be ideal. Anyway assuming it's the common "version jump - no space" problem you need to spin up some WLC 9800 CL (cloud) VM under ESXi. Only have one WLC up...
Here's the solution for a 9130 stuck at BTLDR. You'll need to have the TFTP server setup with the right file as shown.(BTLDR) #setenv ipaddr 192.168.1.66setenv netmask 255.255.255.0setenv serverip 192.168.1.2setenv tftpdirsaveenvSaving Environment to...
An old thread but worth adding to:The 819G routers user the Freescale QorIQ P1025 dual-core processor, which is an awesomely fast and makes the 819G an ISR G2 router.The 819G can route at 100mbps no problems and at 10% CPU. I've terminated a 300Mbps ...
Hi,Are you using multimode or single mode fibre? It's single mode for LR.Are the fibre plugs and sockets the same? Blue into blue, green into green?The transmit power for LR is right on the maximum receive power for LR, so while it *shouldn't* overp...
