Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a firepower 1010 managed with FDM. I have a default config with routed interfaces. Shouldnt the interfaces route between each other by default if they are in the same security zone? The only think i can think of is that I have my fiber mode...
Just curious if this is the way it works or if the bandwidth is shared. I have to splice one of my homeruns to add a switch and was wondering if I would be loosing any speed. Thx
i have 6 vlans on 1 cat5e cable running to 1 port on my esxi server which hosts about 25 servers. these servers are not run very hard, atleast not all at once. Is this going to give me trouble or can I continue to run it like this? firepower 1010 i...
I was wondering why my firewall rules seem to be sleeping at times. I have a simple rule that allows any zones to an IP printer in and it was not working at first but then started working out of the blue while running a ping to it. Its a firepower ...
I have a firepower 1010 managed with FDM and have been trying to expose my ftp server to the web and cant get it out there for nothing. I have allowed access from the ftp server to the outside interface on port 21 and vice versa.Then i setup NAT to t...
This is the strange behavior im seeing, why can I ping a host on a sperate network and not the gateway that host resides on? I have also put them in the same zone.
no, after the lights stopped working, its also stopped giving out IP's withmy old config or the factory reset configuration. I opened a TAC case so Iwill see how that turns out.Ill read up on the NAT exemptionIll send you that packet tracer command i...
I was getting something like command not supported, the unit is down ATMotherwise I would screenshot.Yes the interfaces were enabled and giving out IP's
yes, they are all in the inside zone together. I think this Firepower 1010 is fried because now the ports wont even light up after letting it boot overnight. I reset it and still nothing. This all transpired a few hours after I upgraded the softwa...
