Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need one basic info on RIP settings between two devices over firewall. I believe I just need to allow UDP 520 to the destination address 224.0.0.9 nothing else right. Am I right?
I need to replace the following product as-is due to obsolescence. Please suggest the replacement product and modelWS-C4507R+E (Chassis)WS-X45-SUP6L-E (Supervisor Engine)WS-X4648-RJ45-E (Line card for 48x 10/100/1000(RJ45))WS-X4624-SFP-E (Line card f...
I have one 3850 and 9300 switches that need to be interconnected using LAN cable.3850 supports 100Mbps, I have interconnected using LAN cable but the link does not come up. It gets into error -disabled.On 3850 I see a lot of input errors on uplink po...
I have 9300 switches with OSPF running. I have both L3 and vlan interfaces. I need to disable OSPF on vlan interface. How do I do this? There is no passive interface for vlan interface.
On cisco devices I have set password is below but this is not a strong password, anyone can decrypt it because it's level 7. How can I set more stronger encryption for console password? line con 0password 7 043B321C455B1E1B1D
This command worked but it also stopped OSPF advertising route on other interfaces. My requirement is on vlan interface, OSPF packets should not be advertised but vlan network on other OSPF interfaces should be advertised. How can I do this?
